- Chapter 2 sic: static routing and basic router configuration password#
- Chapter 2 sic: static routing and basic router configuration series#
Enables the GE interface, changing its state from administratively down to administratively up. Router config-if ip address Sets the IP address and subnet mask for the specified GE interface. Enters the configuration mode for a Gigabit Ethernet interface on the router.
You can connect WAN interfaces either by using straight polarity connectors or reversed polarity connectors. Disables the router from translating unfamiliar words typos into IP addresses.
Chapter 2 sic: static routing and basic router configuration password#
Specifies an encrypted password to prevent unauthorized access to the router. Enters global configuration mode, when using the console port. To configure the global parameters for your router, follow these steps.
Chapter 2 sic: static routing and basic router configuration series#
We should run the following commands to configure banners on the switch.This module provides basic configuration procedures for the Cisco M Series ISR and contains the following sections. We can also add a security warning in the banner message to warn users against unauthorized access to the switch. It helps identifying the switch we log into and its configuration and usage guidelines. Banners can be used to display a brief message about the switch when someone logs in. We will configure telnet password on line 1. There is only one console line on a cisco switch. We can see that we first exit from the interface configuration mode config-if exit because the default gateway applies to the whole switch, not just to an interface. The exit command brings us back into global configuration mode from specific configuration mode. The no shutdown command turns on the interface vlan1. Packet Tracer - Lab 6 : Basic router setup This mode enables us to run commands that configure switch settings that apply to the whole switch.
To configure management IP address on the switch, run the following commands. Configuring management IP address to the switch or router allows us to connect to the switch or router from remote locations using either Telnet or HTTP. The rest of the commands are used to exit from global configuration mode. The first two commands allow us to access the global configuration of the switch. Run the following commands for naming the switch. Naming the switch can ease management and identification of the switch. We will simulate the same thing in Packet Tracer.Ĭonnect as shown below. To configure a Cisco switch using Cisco IOS, we must connect a computer to the console port of the switch using a rollover cable. In this chapter, we are going to configure the name of the switch, set management IP address to the switch, configure console and telnet passwords and lastly configure message of the day banner for the switch.
0 kommentar(er)
